One nice and stiff roof panel ready for an insert later on that will be removable. The insert can bolt through the newly made flanges with T type rubber seal in between.
Doing the last few things I was asked to be done. Cutting down the window surrounds. Taking 5.5" out of the height and have to add to the length across the top. Fortunately the profile is pretty much the same all the way around so can use what came off the sides to fill the gap left at the top.
Window surround, or garnish, done on the passenger door. Easier to keep things straight and level by clamping down on the bench and checking along the edge of it for straightness. Use a steel ruler as well.
Here now you can see why leaving that difference in door width at the join would not have worked. It would have shown up terribly! Windscreen pieces needed doing as well. One side done and the other still to go.
Last of the fabrication work done. Doesn't look much different than when it arrived here less than 2 weeks ago from this far away!
[INDEX]